Adopt high-definition imported sensor, wide-angle glass lens

Dual-control front-view rear-view dual-purpose vehicle camera

The default small butterfly unmarked forward-looking camera

Can be freely switched to rear view camera

You can twist off the front shell of the small butterfly bracket and replace it with the 18.5 punched front shell.

Cut off the green and white wires. Change to a marked mirrored rear view.

Specification:

Image sensor: CCD480 line

TV system: NTSC/PAL

Effective pixels: 688*582

Horizontal resolution: 480TVL

Screen display: mirror image with ruler line

Night vision: LED white light night vision

Minimum Illumination: < 0.1

Viewing angle: 150°

Waterproof: IP68

Video output: RCA connector, 1.0Vp-p, 75ohm

Signal-to-noise ratio: better than 48db

Current consumption: 60mA

Power supply: DC 12V

Operating temperature: -20°C to 80°C, max RH95%

Installation method: adjustable external screw installation, built-in installation

Video cable length: 6m

Power cable length: 1m

A. White switch wire (parking lineswitcher)
B. Green switch wire (mirror switcher)
Instructions:
• If you need a backup camera with parking line, please cut both green and white wires.
• If you need a backup camera without parking line, please no cut green wire.
• If you need a front camera with parking line, please cut white wire.
• If you need a front camera without parking line, please not cut any wires.
Reminder: This camera is used as a front camera without distance scale line as default. 

if you want to change it to a rear-view camera, please switch off electrical power and then connect them again, 

so it can convert successfully.

1:If u choose only camera , u will get like below photo

include:

1*Car rear view camera

2*Install the foam screw

1* Hole opener

1*18.5 circlip front shell

2:if u choose full kit , u will get

include:

1*Car rear view camera

1*6m RCA video cable

1*1m power cable

2*Install the foam screw

1* Hole opener

1*18.5 circlip front shell